Plastic magnetic pumps

Description of Product Models

　　msh - f - 44 - 0 - c - c - v - 5 - v38 - a - bt

　　1 - Model Numbers: MSH, MSHG

　　2 - Pump body material: F-GFRPP, C-CFRPP, E-ETFE, P-PVDF

　　3 - Outlet size: 44:40x40mm, 45:50x40mm, 46:65x50mm

　　4 - Horsepower: 0:1/2HP, 1:1HP, 2:2HP, 3:3HP, 5:5HP

　　5 - Pump shaft material: S-SIC, C-CERAMIC, T-TITANIUM (Ti)

　　6 - Bearing material: C-CARBON, P-PTFE, S-SIC

　　7 - Rubber material: E-EPDM, V-VITON

　　8 - Frequency: 5-50Hz, 6-60Hz

　　9 - Voltage: V38:220V/380V/3Φ, V44:220V/440V/3Φ, V41:208V/415V/3Φ

　　10 - Specific gravity limit of medicine: 50HZ:A-1.2,B-1.5,C-2.0,60HZ:D-1.2,E-1.5,F-2.0

　　11 - Motor explosion-proof grade: CT4-ExdIICT4, BT4-ExdIIBT4

Technical Parameters

　　Lift: 0-31m

　　Flow rate: 1-875L/min

　　Material: GFRPP, CFRPP, PVDF, ETFE

　　Voltage: 220V/380V

Four innovations

　　1/GFRPP, CFRPP, PVDF, ETFE material, excellent corrosion resistance.

　　2/ No shaft seal design, so that the magnetic pump to say goodbye to leakage.

　　3/Use RuFeB and SmCo high quality magnets, high temperature resistance and strong magnetic force.

　　4/ Worm shell design, impedance internal consumption becomes smaller, noise reduction.

Comprehensive technical upgrades

　　※ Pump head and motor connecting feet are one-piece moulding, stable and solid, long service life, maintenance and disassembly is more simple and convenient.

　　Magnetic drive, no shaft seal design, good sealing, will not cause leakage of chemical liquid.

　　※ Impeller and inner magnet are moulded in one piece to strengthen the strength of the impeller and improve the efficiency.

　　※ Combined RF-type flanges with adjustable screw holes can avoid leakage due to flange deformation caused by piping pressure, in addition to providing convenient piping.

　　※ The position of the magnetic capsule can be magnetically controlled by accurately setting the relative positions of the passive and active magnets, so that the rear end of the bearing does not come into contact with the rear thrust ring even when the pump is idling, which effectively suppresses frictional heat and ensures lubrication of the friction area.

　　※ The front and rear casing of the pump are designed in the shape of a partial worm shell, and after assembly, the overall ideal spiral shape of the chamber is obtained, which effectively suppresses the leakage phenomenon caused by the liquid ejected from the impeller and flowing back into the pump chamber again, and thus directs the liquid to the outlet of the pump in a smooth and efficient manner.